M*CARBO Brotherhood

Trigger issues on my Gen 1 sub 2k

Hello guys!!

I’m a new owner of a sub 2k and was out and dumped about 500 rounds through it the past 2 days. I started to have issues with it not loading rounds and jamming. I pulled the entire gun apart and cleaned it from the trigger springs up. It loads 100% of the times, bolt runs smooth but now when I pull the trigger nothing happens. If I work the safety back and forth rigorously or work the bolt back and forth rapidly it will allow me to pull the trigger and the hammer drops. There is something going on with the safety bar. Any vids or help on this would be greatly appreciated.

Cheers!!

4 Likes

@scott_r Welcome to the Brotherhood Scott. Try loosening the screw located just above the trigger’s pivot point just a little bit. This has worked for some. If that works you may have a trigger bar rubbing against the plastic grip halves. Chris mentions this in one of his videos.

2 Likes

Thanks!! Where do I find the videos on that?

2 Likes

Welcome Scott !
Start here

3 Likes

Welcome to the Brotherhood, Scott. You might want to take a look here for LOTS of Sub2k videos:

https://www.mcarbo.com/kel-tec-sub-2000-installation-videos.aspx

3 Likes