M*CARBO Brotherhood

SCCY CPX-2 Trigger spring installation

Ok so I ordered the trigger spring kit for my sccy cpx-2, and followed the video online perfectly, I’m trying to hammer the 1st frame pin out and it seems like my 3/32nd punch is stuck in the frame and the pin is about halfway out. I have hammered it over and over and doesnt seem like I’m making any progress. I’m scared to hammer too hard bc I dont wanna break the frame. Any help on this topic would be greatly appreciated

2 Likes

Welcome to the Brotherhood, Joshua. Can you get the punch out and try a smaller one? I definitely wouldn’t try to hammer this one in any more.

3 Likes

I cant get the punch out, any ideas on how to do that?

1 Like

Can you get the pin out the other side with pliers or something and use a smaller punch to push the bigger one back out?

3 Likes

@Jberg23 Turn the frame upside down with the punch facing down. Put something under it to hold the punch off of your table. Smack the steel pin inwards slightly, that should loosen your punch enough to pull it out. Check the punch’s end to see if it has flattened or has a burr on it.

3 Likes

Okay let me try that, thank you