M*CARBO Brotherhood

SCCY CPX 2 magazine spring upgrade

Hi folks, new to the forum.
Having made a cursory search, I didn’t see any discussion relative to the possibility of developing a stronger, better quality spring for the SCCY CPX 2 magazine. I measured the length of a factory spring, loaded the magazine, set it aside for just one week, carefully removed the spring and found it to have compressed almost an 1/8 of an inch. As a result, the follower would not raise the slide lock into position to hold the slide open. I’ve also tried increasing the angle of the last coil, that inserts into the follower, to put more pressure on the slide lock. This helps, but only until the spring fatigues again.
If this has already been discussed, please point me to topic.
Thanks,
CrossTrainer

1 Like

Welcome @CrossTrainer to the clan.

2 Likes