M*CARBO Brotherhood

Ruger PC Carbine Chassis extended mag release

I have a Ruger PCC Chasis, part number 19122. I purchased basically all of the MCarbo parts for it. The only one I am having an issue with is the mag release, to the point I have the stock mag release in it still. When installed the MCarbo part binds and if the screw is fully tightened the mag release is not functional. Is this a known issue with extended mag release with the PCC Chasis model?

1 Like

@Flamethrower Welcome to the Brotherhood. Don’t forget to go to the First Post Here: Introduce Yourself! thread and say Hi to everybody.

4 Likes

@Flamethrower Welcome aboard.

4 Likes

@Flamethrower Welcome to the crew…:wave:
Sounds like the screw is over tightened. Same thing happens with the OEM release button if the screw is over tightened.
Give M*CARBO A call in the morning and ask about it.

3 Likes

@Flamethrower welcome to the forum

3 Likes

first post, posted. :wink:

4 Likes

Welcome here…come on in…:wave::grinning:

2 Likes

It is not over tightened, when it works with the M*Carbo part the screw is not tightened down all the way. If I tighten the screw just to where it is all the way threaded it binds, without even torquing it down.

2 Likes

Have you contacted M*CARBO YET? (Recommended 3-9-20)

I use the OEM mag release so I’m not much help…sorry.

1 Like