Aluminum trigger install on Gen 1 question

Hello all, installing the MCarbo alum trigger/barrel latch upgrade set in my Gen 1. In the instruction vids a Gen 2 is used for the demo. In my Gen 1, where the trigger passes thru from the grip interior to the exterior, the grip sides are not a square vertical relief- a web extends rearward. This pushes the ‘at rest’ trigger position to the rear. Do I cut some of that web so that at rest, the new trigger matches the angle of the OEM trigger? Any other fixes for this?
Thanks for your help

1 Like

DOH! Never mind, simple fix. I just used a small round file in the contact area until I got full travel.

1 Like